Как записать голос качественно дома⭐dynamic mic~connection & rec

Как записать голос качественно дома⭐dynamic mic~connection & rec

January 17, 2020 82 By Kailee Schamberger


Hello my friends. Today I decided to record a small video lesson for you on how to record a voice on a computer using a simple dynamic microphone. Why dynamic? Because only condenser microphones can be connected directly to the computer. These microphones are often either too expensive, professional, or they have poor quality when we are recording our voice for a song. because, inexpensive condenser microphones are designed to record ordinary conversational speech. In the other hand, dynamic microphones are much more affordable, and at the same time they often have a fairly high quality voice recording. Dynamic microphones are more ordinary and are often found in every professional’s hand and at the market They do not require additional power (unlike the condenser mic) and they are also much easier to be used and connected by you In this video I will show how to connect a simple dynamic microphone to a computer using this simple mixer. As for the mixer, its price ranges from 45 euros and above It is advisable to have a mixer with at least one microphone input. Such an input typically has low, mid and high frequency controls as well as a sensitivity control. If you do not want to use these controls, then you can simply set them to zero and also set the sensitivity to the number one, on the dial of the clock, as the sound producers usually say. And then, later clean your voice with the recording program that you use in your computer. At this stage, the most important thing is to keep track of the mixer output LEDs while recording. They should glow in the green zone and in no case in the red zone, even briefly. To do this, you must therefore reduce the sensitivity control and the volume of the microphone channel you are using. You need to pay attention to this and set up the mixer before you start recording to a computer. Otherwise, the voice will be recorded with distortions and this is very important not happen! Since, it will be impossible to be corrected later in the computer program while mixing the song. So our actions are as follows: We connect the microphone to the microphone input of the mixer (or to the normal line input if there is no microphone input, as I do now) Turn on the mixer and try the microphone, by setting it in the green zone of the LEDs. test test test … then we connect the main output of the mixer to the blue (that is, linear) input of the computer. After that, we open the computer Well, the computer has opened … We run the audio recorder on the computer. (In my case, this is a free program for recording and processing voice AUDASITY) We select the appropriate setting in the program so that it recognises the line input of the computer we use (and not the microphone input for example, which is not used in our case) If we are recording a song, then we start the soundtrack from any other device (for example, from a mobile phone and listen to it with headphones while playing the song. This is so that the soundtrack is not “heard” by our microphone) Then we turn on the program for recording. Test test ….. After the end of the voice recording, stop the recording. We see the voice recorded without distortion. This is the little experience that I wanted to share with you today. I hope it was useful to you. Give me a like if you find it useful and subscribe to my music channel where I will exhibit, from time to time, training videos for beginners. I hope that they will be necessary for you See you in the new lessons friends!